2018 CAN-AM Spyder F3

The defect

Bombardier Recreational Products (BRP) is recalling certain 2017-2019 Can-Am Spyder F3 and RT motorcycles. The engine output shaft may fatigue and break, resulting in a loss of drive power.

The risk

A loss of drive power increases the risk of a crash.

The remedy

The output shaft will be replaced based on the mileage of the vehicles. Owner notification letters were mailed February 5, 2025. Owners may contact BRP customer service at 1-888-272-9222.

Bombardier Recreational Products, Inc. · up to 8,721 vehicles across all model years covered

The defect

Bombardier Recreational Products, Inc. (BRP) is recalling certain 2015-2019 Can-Am Spyder F3 and RT motorcycles. The front sprocket may be defective and prematurely wear, resulting in a loss of drive power.

The risk

A loss of drive power increases the risk of a crash.

The remedy

Dealers will perform an interim repair until parts become available. Once parts are available, the front sprocket will be replaced, free of charge. Owner notification letters were mailed May 26, 2022. Owners may contact BRP customer service at 1-888-272-9222.

Bombardier Recreational Products, Inc. · up to 30,389 vehicles across all model years covered

BRP has a recall for the output shaft for the 2018 Can Am Spyder F3T. Just after receiving the recall letter the output shaft on my Spyder went out. My bike does have more than the 37,000 miles on it. This is a known defect with this Bike. It is not right that BRP knows this part is defective and has a milage limit on it. This bike is my daily driver for work. I have contacted BRP and have been told as my bike has more miles that i am just up a creek without a paddle as I still owe more than $11,000. on this bike. I have asked for a call back and have not received any. I think this is wrong of them to put a milage cap on this part as it is designed to last the bike its lifetime. I have even …

NHTSA complaint 11699733, quoted in part. Filed by an owner and not verified by NHTSA or by us.

The affected part is the engine output shaft, which is part of the vehicle’s powertrain and propulsion system. BRP issued Recall 24V-728 for this defect, stating that the shaft can break and cause a sudden loss of propulsion, creating a safety hazard. I received the recall notice in April 2025 and have been unable to safely operate the vehicle since then. I contacted every authorized Can-Am dealer within 150 miles, but all confirmed they could not perform the recall repair because replacement parts were unavailable. The first available dealer, Team Mancuso Powersports Southwest, accepted the vehicle on September 23, 2025, and has now had it for over three weeks with no estimated repair …

NHTSA complaint 11693290, quoted in part. Filed by an owner and not verified by NHTSA or by us.

The contact owns a 2018 Can-Am Spyder F3. The contact received notification of NHTSA Campaign Number: 24V728000 (POWER TRAIN); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue. The manufacturer was not made aware of the issue. The contact had not experienced a failure. Parts distribution disconnect.

NHTSA complaint 11655876. Filed by an owner and not verified by NHTSA or by us.

While riding at approximately 65 miles per hour, the vehicle started to get slower and slower until it eventually came to a stop. The vehicle had 15,451 miles on the odometer at the time of the failure and had to be towed to a dealership for inspection / repair. The dealer advised that the shaft that the sprocket rides on had excessive play and that the intermediate shaft failed / snapped.

NHTSA complaint 11602625. Filed by an owner and not verified by NHTSA or by us.

While driving on a straight stretch of highway at posted highway speeds of 75mph, no additional acceleration, torque, turning, or high rpms, my bike experienced a sudden jolt and immediate loss of propulsion. I was able to pull to the side of the highway to find my front left drive shaft had completely sheared off, the front sproket (currently under recall, which has not yet been replaced according to my dealer's service records) thankfully was caught by the frame underneath or it could have flown out into traffic and hit the other biker behind me or other traffic, or causing me to crash. My drive belt remained fully in tact but was dislodged and dragging, another risk factor for crash. …

NHTSA complaint 11594808, quoted in part. Filed by an owner and not verified by NHTSA or by us.

17,500 miles

The contact owns a 2018 CAN-AM Spyder F3. The contact stated that the parking brake was inoperable. The parking brake had seized. The brake warning light was illuminated. The vehicle was taken to the local dealer where it was diagnosed that there was a defective parking brake motor and a TSB regarding the failure had expired. The manufacturer was contacted and referred the contact to the dealer for assistance. The failure mileage was approximately 17,500.

NHTSA complaint 11515583. Filed by an owner and not verified by NHTSA or by us.